Open House 2019
AJ Solutions Open House mercredi 27 mars de 11h00 à 18h30 jeudi 28 mars de 11h00 à 18h00 |
![]() ![]() |
Programme Open House :
Vous apprécierez les différentes démos en directs de l’ensemble de notre gamme et vous aurez accès à énormément d’informations techniques pendant que vous serons servies des collations et consommations culinaire à volonté.
Quelques démonstrations intéressantes:
- Arburg 50 tonnes entièrement équipé avec des équipements pérphériques & changement de couleurs efficace avec produits de purge.
- Démonstration de sécurité: Que se passe-t-il si un tuyau d'eau se brise sur une unité HB-Therm avec une eau de 160°C ?
- Table pour entretien de moule avec démonstration de nos différents produits d'entretien, nettoyage des circuits d'eau du moule avec HB-Clean.
- Broyeur Neue Herbold LM 450/600 pour grande pieces.
- Sécurité pour le moule avec caméra Nouveau ! "Télécharger le catalogue"
mercredi 27 mars
- 11h00: Doors open: our suppliers are ready to demonstrate their products on their islands
- 12h30: “Automation and Multi-task moulding systems: innovation as source of
added-value and productivity in the plastics Industry" by Plasdan - 13h15: “Boost Overall Equipment Efficiency with Quick Mould Change Systems
by EAS Change Systems - 14h00: “Pressurized hot water versus hot oil - which is more dangerous?" by HB-Therm
- 15h00: “Maximising Foaming Technology with injection” by customer Prince-Weiss
- 16h00: “Extreme Energy Saving in Cooling of the Plastic Process” by Eurochiller
- 16h45: "Additive Manufacturing with Serial Material with Arburg Plastic Freeforming" by Arburg Germany
- 17h15: Tribute and farewell reception on the occasion of Simon Bemong’s retirement director Arburg Belgium
- 18h30: Closing of open doors
jeudi 28 mars
- 11h00: Doors open: our suppliers are ready to demonstrate their products on their islands
- 13h00: “Automation and Multi-task moulding systems: innovation as source of
added-value and productivity in the plastics Industry" by Plasdan - 14h00: “Promix mixing nozzles – save Masterbatch and reduce your scrap rate”
by Promix Solutions - 15h00: “Extreme Energy Saving in Cooling of the Plastic Process” by Eurochiller
- 15h45: “Boost Overall Equipment Efficiency with Quick Mould Change Systems
by EAS Change Systems - 16h30: “Pressurized hot water versus hot oil - which is more dangerous?" by HB-Therm
- 18h00: Closing of open doors
PARKING
Cliquez ici pour les instructions
PARTICIPANTS IN ACTION
![]() |
![]() |
Plastiwin | Arburg |
![]() |
![]() |
Prince-Weiss | Mikrocentrum |